Basic structure and cleaning of filling and sealing machine

Clean the surface of the filling and sealing machine, the bottom plate, the upper mold double rocker plate, the pipe trench, the inner pins in the lower mold, and the correct positioning rod on time (the power must be cut off to repair at room temperature). The transmission system should be equipped with salt free butter at the positions of the upper mold double seesaw, pressure rod rolling bearings, gear rack and positioning pin, slide rail, etc. Ensure the performance indicators of the equipment on time. Method for removing the toothed cutter: First, use cotton balls to insert the two drainage holes of the lower mold, pour boiling water into the upper mold pipe groove, fill the upper mold double rocker plate, and promptly send it into the upper mold double rocker plate. Press the lower mold tightly and soak the toothed cutter for multiple minutes until the removal is completed, and continue multiple times.

The filling and sealing machine system consists of a cleaning part and a gluing part, and its characteristics depend on the fact that the cleaning part is composed of nine parts. The axial force remote rod organization and the chain wheel chain are connected to form a whole chain wheel chain organization. According to the transmission chain and the transmission gear rotating and shaking mechanical equipment and its following sleeve connection, an L-shaped support rod flipping bar is placed in the transmission gear rotating and shaking organization. The two chain wheel chains are respectively installed on both sides of the flat plate chain wheel chain, so that the flat plate chain wheel chain produces a circular chain wheel chain. The bottle bowl transmission chain flipping subjective factor is set on it. The filling and sealing mechanism of the gluing part is connected to the transmission belt and subjective factor, and the pressing and flipping organizations rely on the cap sealing crank arm. Organize assembly in the upper support frame, The capping machine and fully automatic sealing machine rely on the capping sealing crank arm to organize and assemble in the upper support frame. The bottle feeding and clamping organization is placed on the bottle feeding and clamping swing rod, and an anti retreat wedge groove is set on both sides of the bottle feeding and clamping swing rod. The fully automatic capping organization is placed above the support frame, and the reducer and motor are assembled into a group, connected to the subjective factors. The bottle channel support plate lifting system is placed on the lower support frame, and four bottle channel elevator support frames are evenly spaced and set on it. The bottle transport channel is built above the bottle channel elevator support frame, and the bottle filling is placed on the bottle transport channel, closely attached to the bottle feeding swing rod.

After the application of the filling and sealing machine, attention should also be paid to its maintenance. When disassembling the piston rod during maintenance, the fixed screws on it should be removed separately to prevent endangering the processing technology regulations of another one when disassembling. Before cleaning the filling and sealing machine of the piston machine, the remaining products inside should be removed, and then the material bucket should be filled with mild cleaning solution. The cylinder has been lubricated at the original factory. Please do not open or add any lubricating grease to ensure daily cleaning of the surface of the tail sealing machine. When not in use, turn off the power to solve the problem. In addition, while persistently maintaining and properly applying the filling and sealing machine, it is also necessary to carry out inspections and adjustments on time. Only with such a tailgate can one work with good physical and mental health.

The fully automatic filling and sealing machine is different from the automatic sealing machine, which is a small and medium-sized manual sealing machine. The fully automatic canning is also fully automatic, and only the subsequent capping and boxing stages are carried out manually. The key function of the fully automatic sealing machine is canning, with fewer additional functions. Unlike the automatic filling and sealing machine, which can be equipped with conveyor belts, capping machines, labeling machines, packing machines, fully automatic sealing machines and other ancillary machinery and equipment.